Introduction

The named Defects Analysis System (DAS) is designed for those QC sections of any manufacturers who need instant, fast and accurate statistical analysis of any defects found in their production line. And this system is especially suitable for those automated production line where any delay in discovery of defects causes may cost large economic losses.

System Configuration

PC Central Control System
- Pentinum 166 CPU
- 32 MB onborad RAM
- 4.3 GB Harddisk Drive
- 1.44MB Floppy Drive
- SVGA Controller which supports 800 x 600 true color mode
- Windows 3.11, Windows95 or Windows NT O/S
- at least one unused Serial port
- SVGA Monitor

Remote Data Entry Terminal
(one to eight terminals per each PC Central Control System)

Windows based Graphic Printer

Mulit-port Serial Adapter
(optional for more than one remote terminals usage)

Software Features

• Handle up to 99 different Models information
• Support Microsoft Windows NT or Novell Network environment
• Handle up to 99 production lines under network environment
• Each production line may consist one or two different models
• Instant on-line Bar-chart view of defects detected
• Instant on-line graphic view of both First Pass Yield Rate and Defects Rate
• Detail Data Code Entry report
• Periodic First Pass Yield Rate report
• Daily, weekly and monthly Line QC report
• Daily Repair report
• Various statistical defects analysis reports based on Cavity, Parts, Locations etc.
• Password protected User Authority Profile
• Accept both Chinese and English data input